You are ready to begin programming. Keep in mind that all the programmable features are set to the factory default. You do not have to go through this procedure unless you want to turn a feature "OFF" or "ON", change the number of rings, security access code(s) or destination port(s).
When entering the programming mode The Stick II will signal you with audible beeps from the handset. These beeps tell you that you have entered the programming mode "OK" and to "PROCEED". You will have 30 seconds to enter your next command.
Your "next" command could be to modify a feature or to save and exit. If nothing is entered within those 30 seconds, The Stick II will signal with the "OK" beep. Your programming changes will not be saved and you will have exited the programming mode.
It is as if you DIALED "90" for the No Save/Exit command.
Place a call to your friend from LINE 1. (Do not call into LINE 2.)
Wait at least 5 seconds before continuing.
DIAL "# # 9 9" on your telephone key pad. The LED will begin blinking rapidly.
Immediately listen for the "PROCEED" (Bee-Bee-Beep) tones. You have 30 seconds to begin programming.
You are now ready to modify any programmable feature.
DIAL the Register Number of the feature you want to modify. (see chart on p. 20-24)
Next DIAL in the Program Range. (see chart on p. 20-24)
Immediately listen for the "OK" tones (Bee-Bip), then the "PROCEED" tones (BeeBee-Beep) or "ERROR" tones (low pitch beeps) then "PROCEED". You have 30 seconds to begin the next command.O
Turning "ON" your Unanswered Call Silent Transfer LINE 2
DIAL "041" - "04" is the Register Number and "1" is the Program Range which means "ON"
Immediately listen for the "OK" tones (Bee-Bip), then the "PROCEED" tones (Bee-Bee-Beep) or "ERROR" tones (low pitch beeps) then proceed. You have 30 seconds to begin the next command.
Changing your Rings to Answer (RTA) LINE 1 and suppressing the devices connected to Voice 1 from ringing during the RTA
DIAL "1541"-"15" is the Register Number, next enter the Program Range of "41". "4" is the number of rings that will occur on every Line 1 phone before The Stick II takes the call and processes it and "1" tells The Stick II to suppress any of the devices hooked to Voice 1 from ringing until after the 4tth ring.
Immediately listen for the "OK" tones (Bee-Bip), then the "PROCEED" tones (Bee- Bee-Beep) or "ERROR" tones (low pitch beeps) then proceed. You have 30 seconds to begin the next command.
Changing the Security Access Code for Port 3
DIAL "1137*6"-"11" is the Register Number and the Program Range is "37*6" - the new access code for Port 3. See the Don’ts of SAC Programming before selecting your Access Code.
Immediately listen for the "OK" tones (Bee-Bip), then the "PROCEED" tones (Bee-Bee-Beep) or "ERROR" tones (low pitch beeps) then proceed. You have 30 seconds to begin the next command.
DIAL "80"
You will hear the "OK" tone TWICE (Bee-Bip, Bee-Bip). The LED will go back to normal operation.
Remember: The only reason you would hear an error tone when saving and exiting is if you have programmed all ports to default to Line 2 (can't enter programming mode from Line 2) and Auto-Line Select OFF on ALL ports. You will be unable to Save & Exit until the situation is remedied. Assign a port to default to Line 1 or turn Auto-Line Select ON for at least one port.
Programming complete and changes are saved.